Don't see your question here? Call or text us at (208) 996-0791.
Polyaspartic is a type of coating chemistry, like epoxy, but it cures much faster and holds up better against UV light and cold. We use a full epoxy system for the base layer and a polyaspartic topcoat, which gives you fast cure times without sacrificing the deep bond epoxy provides underneath.
Most single-car and two-car garages are done in one day. Larger spaces or jobs needing extensive crack repair can take longer. We'll give you a specific timeline at your free on-site quote.
You can typically walk on the floor within about 24 hours. We'll tell you the exact wait time for foot and vehicle traffic based on the products used and the weather during your install.
You can, or we can handle it for you as an add-on for $2/sq ft. We'll move everything out before we start and put it back once the floor has cured. Just let us know when you book your quote.
We mechanically grind the concrete with diamond tooling to open the surface pores, then repair cracks, pitting, and control joints before any coating goes down. This is the step that most determines whether a floor lasts. We don't skip it or shortcut it with an acid-etch instead.
Yes. Coatings need a minimum surface and air temperature to cure correctly, which matters for outdoor patios especially. We check the forecast before scheduling any exterior install and will reschedule rather than install in conditions that would compromise the cure.